The engine warning light comes on, an AdBlue or emissions warning appears – maybe even a countdown to a no-start – and the fault memory shows P20EE. The engine control unit has found that the SCR system is not reducing nitrogen oxides (NOx) enough. Before replacing an expensive catalyst, it is worth checking AdBlue, dosing and the NOx sensors.
What does P20EE mean?
The engine control unit compares the NOx values before and after the SCR catalyst. If the NOx content after the catalyst does not drop enough, P20EE is stored.
Note: the meaning is defined by the OBD-II standard; some manufacturers add their own sub-codes. Always read the complete fault memory including the freeze-frame data.
Typical symptoms
- Engine warning light and an AdBlue or emissions warning
- Depending on the manufacturer, a countdown to a no-start ("engine start not possible in … miles")
- Reduced power
- Sometimes a sharp smell of ammonia at the exhaust
- Higher or unusually low AdBlue consumption
The most common causes
| Cause | How to check it | Note |
|---|---|---|
| Poor AdBlue quality (diluted, too old, contaminated) | Measure the urea content with a refractometer (target 32.5 %), drain and refill if necessary | Simple first step |
| Blocked or crystallised AdBlue dosing injector | Look for white crystals, run a dosing quantity test with a diagnostic tool | Common with lots of short trips |
| NOx sensor before or after the SCR catalyst giving wrong readings | Compare NOx values before and after the catalyst with dosing active | NOx sensors age and become inaccurate |
| AdBlue pump, line or heater | Check system pressure and heating, especially in winter | |
| Exhaust leak upstream of a NOx sensor | Check the exhaust system for leaks | Distorts the measurement |
| High raw NOx emissions from the engine (e.g. EGR fault) | Check other fault codes and EGR operation | The SCR system can no longer keep up |
| Aged or contaminated SCR catalyst | Only after ruling out the other causes | Most expensive fix |
Step-by-step diagnosis
- Read the complete fault memory: related codes for the NOx sensors (e.g. P2200, P229F), AdBlue dosing or EGR give important clues.
- Check the AdBlue quality and refill the tank if in doubt.
- Run a dosing quantity test and check the dosing injector for crystals.
- Compare NOx values before and after the SCR catalyst in live data: with a warm catalyst and dosing active, the downstream value must be clearly lower. Implausible values point to a NOx sensor.
- Check the exhaust for leaks and ask the manufacturer about software updates.
- Only then assess the SCR catalyst.
Can I keep driving with P20EE?
In the short term, usually yes. However, many Euro 6 vehicles start a countdown: if the cause is not fixed, the engine cannot be restarted once it reaches zero. So have the fault checked in good time.
If a NOx sensor is faulty
Find NOx sensors for your vehicle here: NOx sensors. Pay attention to the fitting position: the sensors before and after the SCR catalyst often have different part numbers. More guides: Faulty NOx sensor? 5 warning signs and Ammonia smell from the exhaust.
Frequently asked questions
Is the SCR catalyst always faulty with P20EE?
No. AdBlue quality, a blocked dosing injector or a NOx sensor reading incorrectly are often the cause. The catalyst is the last step of the diagnosis.
Does a new NOx sensor need to be calibrated?
Depending on the manufacturer, learned values must be reset or an adaptation carried out with a diagnostic tool after replacement.
Which NOx sensor is the right one – before or after the catalyst?
The related codes and live values tell you. Also compare the part number on the installed sensor.
Does simply refilling with fresh AdBlue help?
If quality was the cause, yes – after refilling, clear the fault and do a test drive. With other causes, P20EE will come back.